Eaton NetDirector B064-016-04-IPH Manual

Also see for NetDirector B064-016-02-IPH: Installation instructions

15Logging Into the B064-Series KVM SwitchAP Java Client LoginAP Windows Client LoginIn those cases in which the Administrator does not want the B064-Series KVM Switch to be available via browser and the remoteuser is not running Windows, the AP Java Client provides access to the KVM switch.After downloading the AP Java Client, go to the location on your hard disk where you downloaded the program and double-clickon it to bring up the connection screen. The AP Java Client connection screen is the same as the Windows version, except that itdoes not contain a menu bar with File and Help menus.Note: When accessing the AP Java Client for the first time, you will be prompted to provide a serial number. This serial number can be found on the CDthat came with your KVM.The Connection ScreenA description of the contents of the Connection Screen is given in the following table:Item DescriptionMenu Bar The Menu Bar contains two menus; File and Help. The File Menu allows the operator to Create, Save, and OpenWork files.Server ListEach time the WinClient.exe file is run, it searches the User’s LAN segment for B064-Series KVM Switches, andlists the ones it finds in this box. Double-click on any of the units in this list to connect to it.Note: For a switch to show up in the Server List, the Enable Device List check box in the Operating Mode page (see OperatingMode section under Device Management in OSD Operation for details) must be checked and the Program service port in theNetwork page (see Network section under Device Management in OSD Operation for details) must be set to the same number asin the AP Windows Client Port field.ServerThis area is used when you want to connect to a B064-Series KVM Switch at a remote location.• Click on the IP drop-down and select an address from the list. If the address you want is not listed, key in thetarget IP address in the IP field, and its port number in the Port field.• When the IP address and port number have been specified, click Connect to bring up a login dialog box.Provide a Username and Password as provided by your system administrator and click OK to establish aconnection with the B064-Series KVM Switch.• When you have finished with your session, click Disconnect to end the connection.Message List Lists status messages regarding the connection to the B064-Series KVM Switch.Switch toRemote ViewOnce a remote connection with a B064-Series KVM Switch has been established, this button becomes active.Click it to switch to the KVM Switch’s Main OSD Page.The File MenuThe File Menu allows the operator to Create, Save, and Open Work Files. A Work File consists of all the information specified in aClient session. This includes the items in the Server List and Server IP List.Whenever a user runs the Client program, it opens with the values contained in the current Work File, i.e. the values that were ineffect when the program was last closed.The File menu consists of three items:Item DescriptionNew Allows the user to create a named work file so that its values will not be lost and will be available for future useOpen Allows the user to open a previously saved work file and use the values contained in itSave Allows the user to save the values presently in effect as the current work fileExit Exits the AP Windows Client1. If your KVM is displayed in the Server List, connect to it by highlighting it andclicking on the Connect button.Note: For a switch to show up in the Server List, the Enable Device List checkbox in theOperating Mode page (see Operating Mode section under Device Management in OSDOperation for details for details) must be checked and the Program server port mustmatch what is set in the Network page (See Network section under Device Managementin OSD Operation for details.)2. If your KVM does not display in the Server List, enter in its IP address in the IPserver field and click the Connect button.3. Upon clicking the connect button, you will be prompted to enter yourusername and password. Enter in your username and password and press OK.4. When connected, the Remote View button will be activated. Click on it toaccess the KVM remotely. Click on the Disconnect button to log out of theKVM switch.