Eaton NetDirector B064-016-04-IPH Manual

Also see for NetDirector B064-016-02-IPH: Installation instructions

74Remote SessionPanel Array ModeClicking the Panel Array icon on the OSD Toolbar or ControlPanel invokes Panel Array Mode. Under this mode, the OSDdivides your screen into a grid of panels:Panel Array ToolbarThe Panel Array Toolbar provides shortcut navigation and control of the panel array. The icons in the Panel Array Toolbar aredescribed below:Icon DescriptionClick this icon to keep the Panel Array Toolbar visible at all times. Click it again to make the toolbardisappear after a few seconds.Click and drag any part of the toolbar that is not an icon to move the toolbar to another position on thescreen.Pause panel scanning, leaving the focus on the currently selected panel.Click to move the focus of the Panel Array scan back four panels.Click to move the focus of the Panel Array scan to the previous panel.Click to move the focus of the Panel Array scan to the next panel.Click to move the focus of the Panel Array scan ahead four panels.Increase the number of panels in the array.Decrease the number of panels in the array.Toggle 4/3 aspect ratio.Exit Panel Array mode.• Each panel represents one B064-Series KVM Switch’s ports,beginning with Port 1 at the upper left and continuing fromleft to right and top to bottom.• When the Array is first invoked, it scans through each ofthe ports that were selected for Auto Scanning in the PortSelect and Filter functions, and displays information aboutthe port (port name, resolution, online status, port accessstatus), at the bottom of the panel.Note: The Panel Array scans at one-second intervals. The scan interval isnot user definable.• The number of panels in the array can be increased ordecreased by clicking the Show More Ports or Show FewerPorts icons on the panel array toolbar.• If the computer connected to a port is on line, its screendisplays in the panel. If not, the panel remains blank.• Only ports that are accessible to the currently logged inuser are displayed. For ports that are not accessible, thepanel is blank.• If you move the mouse pointer over a panel, informationabout the port displays at the bottom of the panel.• You can access a computer/server connected to a portby moving the mouse pointer over its panel and double-clicking. This will switch you to the computer exactly as ifyou had selected it from the OSD Main screen.The OSD Toolbar