Eaton Power Xpert 9395C Installation And Operation Manual

68 Eaton Power Xpert 9395C UPS Installation and Operation Manual 164000821—Rev 0644..1100 IInniittiiaall SSttaarrttuuppStartup and operational checks must be performed by an authorized Eaton Customer Service Engineer, or thewarranty terms specified in1.8 Warranty become void. This service is offered as part of the sales contract forthe UPS. Contact an Eaton service representative in advance (usually a two-week notice is required) to reservea preferred startup date.44..1111 CCoommpplleettiinngg tthhee IInnssttaallllaattiioonn CChheecckklliissttThe final step in installing the UPS system is completing the following Installation Checklist. This checklistensures that you have completely installed all hardware, cables, and other equipment. Complete all items listedon the checklist to ensure a smooth installation. Make a copy of the Installation Checklist before filling it out,and retain the original.After the installation is complete, an Eaton Customer Service Engineer must verify the operation of the UPSsystem and commission it to support the critical load. The service representative cannot perform anyinstallation tasks other than verifying software and operating setup parameters. Service personnel may requesta copy of the completed Installation Checklist to verify all applicable equipment installations have beencompleted.NOTE The Installation Checklist MUST be completed prior to starting the UPS system for thefirst time.Distributed Bypass Installation Checklisto Each cabinet in the distributed bypass system is placed in its installed location.o All conduits and cables are properly routed to the UPS cabinets and to the tie cabinet or distribution panel.o All power cables are properly sized and terminated.o A ground conductor is properly installed.o Controller Area Network (CAN) wiring between the UPS cabinets is properly installed.o Pull-chain wiring between the UPS cabinets is properly installed.o Adequate workspace exists around the UPS cabinets, the tie cabinet, and other cabinets.o Startup and operational checks are performed by an authorized Eaton Customer Service Engineer.UPS System Installation