1-7Displaying and Maintaining GVRPTo do … Use the command … RemarksDisplay GARP statistics display garp statistics[ interface interface-list ]Display the settings of theGARP timersdisplay garp timer [ interfaceinterface-list ]Display GVRP statistics display gvrp statistics[ interface interface-list ]Display the global GVRP status display gvrp statusClear GARP statistics reset garp statistics[ interface interface-list ]Available in any viewGVRP Configuration ExampleGVRP Configuration ExampleNetwork requirementsz Enable GVRP on all the switches in the network so that the VLAN configurations on Switch C andSwitch E can be applied to all switches in the network, thus implementing dynamic VLANinformation registration and refresh.z By configuring the GVRP registration modes of specific Ethernet ports, you can enable thecorresponding VLANs in the switched network to communicate with each other.Network diagramFigure 1-2 Network diagram for GVRP configurationConfiguration procedure1) Configure Switch A# Enable GVRP globally. system-view[SwitchA] gvrp# Configure GigabitEthernet1/0/1 to be a trunk port and to permit the packets of all the VLANs.[SwitchA] interface GigabitEthernet 1/0/1[SwitchA-GigabitEthernet1/0/1] port link-type trunk