2-15Create a RADIUS scheme andenter its viewradius schemeradius-scheme-nameRequiredBy default, a RADIUS schemenamed "system" has alreadybeen created in the system.Configure the type of RADIUSservers to be supportedserver-type { extended |standard } Optionalz If you change the RADIUS server type, the units of data flows sent to RADIUS servers will berestored to the defaults.z When the third party RADIUS server is used, you can select standard or extended as theserver-type in a RADIUS scheme; when the CAMS server is used, you can select extended as theserver-type in a RADIUS scheme.Configuring the Status of RADIUS ServersFor the primary and secondary servers (authentication/authorization servers, or accounting servers) ina RADIUS scheme:When the switch fails to communicate with the primary server due to some server trouble, the switch willturn to the secondary server and exchange messages with the secondary server.After the primary server remains in the block state for a set time (set by the timer quiet command), theswitch will try to communicate with the primary server again when it receives a RADIUS request. If itfinds that the primary server has recovered, the switch immediately restores the communication withthe primary server instead of communicating with the secondary server, and at the same time restoresthe status of the primary server to active while keeping the status of the secondary server unchanged.When both the primary and secondary servers are in active or block state, the switch sends messagesonly to the primary server.Follow these steps to set the status of RADIUS servers:To do… Use the command… RemarksEnter system view system-view —Create a RADIUS scheme andenter its viewradius schemeradius-scheme-nameRequiredBy default, a RADIUS schemenamed "system" has alreadybeen created in the system.Set the status of the primaryRADIUSauthentication/authorizationserverstate primary authentication{ block | active }Set the status of the primaryRADIUS accounting serverstate primary accounting{ block | active }OptionalBy default, the RADIUS serversspecified with IP addresses inthe RADIUS scheme are all inthe active state.
