1-12To do… Use the command… RemarksEnable the debugging/log/trapinformation terminal displayfunctionterminal monitor OptionalEnabled by defaultEnable debugging informationterminal display function terminal debugging OptionalDisabled by defaultEnable log information terminaldisplay function terminal logging OptionalEnabled by defaultEnable trap informationterminal display function terminal trapping OptionalEnabled by defaultMake sure that the debugging/log/trap information terminal display function is enabled (use theterminal monitor command) before you enable the corresponding terminal display function by usingthe terminal debugging, terminal logging, or terminal trapping command.Setting to Output System Information to a Log HostFollow these steps to set to output system information to a log host:To do… Use the command… RemarksEnter system view system-view —Enable the information center info-center enable OptionalEnabled by default.Enable information output for aspecified switch in a fabricinfo-center switch-on { unitunit-id | master | all }[ debugging | logging |trapping ]*OptionalBy default, debugginginformation output is enabled,and log and trap informationoutput are disabled for themaster switch in a fabric.Debugging, log and trapinformation output are alldisabled for other switches inthe fabric.Enable system informationoutput to a log hostinfo-center loghosthost-ip-addr [ channel{ channel-number |channel-name } | facilitylocal-number ]*RequiredBy default, the switch does notoutput information to the loghost.After you configure the switchto output information to the loghost, the switch usesinformation channel 2 bydefault.
