1-26To do… Use the command… RemarksEnter system view system-view —Enable the burst function burst-mode enableRequiredBy default, the burstfunction is disabled.With the IRF function enabled, do not enable the burst function. Otherwise, packets may beforwarded improperly. Refer to the IRF Fabric part for the detailed information about IRF.Configuration example# Enable the burst function. system-view[Sysname] burst-mode enableConfiguring Traffic MirroringRefer to section Traffic mirroring for information about traffic mirroring.Configuration prerequisitesz The ACL rules for traffic classification have been defined. Refer to the ACL module ofthis manual for information about defining ACL rules.z The source mirroring ports have been determined.z The destination mirroring port has been determined.Configuration procedureFollow these steps to configure traffic mirroring:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Configure the current portas a source mirroring portmirrored-to inboundacl-rule{ monitor-interface | cpu }RequiredOmit the following steps ifyou redirect traffic to theCPU.Proceed to the followingsteps if you redirect trafficto a port.Quit to system view quit —
