1-5To do… Use the command… RemarksIn systemviewmirroring-group group-idmirroring-portmirroring-port-list { both |inbound | outbound }interface interface-typeinterface-numbermirroring-group group-idmirroring-port { both |inbound | outbound }Configurethe sourceport for theportmirroringgroup In portviewquitUse either approachYou can configure multiplesource ports at a time insystem view, or you canconfigure the source port inspecific port view. Theconfigurations in the twoviews have the same effect.In systemviewmirroring-group group-idmonitor-port monitor-port-idinterface interface-typeinterface-numberConfigurethedestinationport for theportmirroringgroupIn portview mirroring-group group-idmonitor-portUse either approachThe configurations in thetwo views have the sameeffect.When configuring local port mirroring, note that:z You need to configure the source and destination ports for the local port mirroring totake effect.z The source port and the destination port cannot be a fabric port or a member port of anexisting mirroring group; besides, the destination port cannot be a member port of anaggregation group or a port enabled with LACP or STP.Configuring Remote Port MirroringAn S5600 series Ethernet switch can serve as a source switch, an intermediate switch, ora destination switch in a remote port mirroring networking environment.Configuration on a switch acting as a source switch1) Configuration prerequisitesz The source port, the reflector port, and the remote-probe VLAN are determined.z Layer 2 connectivity is ensured between the source and destination switches over theremote-probe VLAN.z The direction of the packets to be monitored is determined.2) Configuration procedureFollow these steps to perform configurations on the source switch:
