1-11 Port Basic Configurationz The auto-negotiation speed configuration on a port is added to this manual. For details, refer tosection Configuring Port Auto-Negotiation Speed.z The configuration for port Up/Down log output is added to this manual. For details, refer to sectionDisabling Up/Down Log Output on a Port.z The storm control function is added to this manual. For details, refer to section Configuring StormControl on a Port.z The feature to display/clear the statistics on dropped packets is newly added. For details, refer tosection Displaying and Maintaining Basic Port Configuration.z The port state change delay configuration is added to this manual. For details, refer to Setting thePort State Change Delay.Ethernet Port ConfigurationInitially Configuring a PortFollow these steps to initially configure a port:To do... Use the command... RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Enable the Ethernet port undo shutdownOptionalBy default, the port is enabled.Use the shutdown command todisable the port.Set the description stringfor the Ethernet port description textOptionalBy default, the description string of anEthernet port is null.Set the duplex mode ofthe Ethernet port duplex { auto | full | half }OptionalBy default, the duplex mode of the portis auto (auto-negotiation).Set the speed of theEthernet port speed { speed-value | auto }OptionalBy default, the speed of the port isauto (auto-negotiation).