2-3To do… Use the command… RemarksConfigure traffic policingtraffic-limit inboundacl-rule [ union-effect ]target-rate [ burst-bucketburst-bucket-size ][ exceed action ]OptionalConfigure packet filtering packet-filter inboundacl-ruleOptionalRefer to the ACL module ofthis manual for informationabout packet filtering.Configure priority markingtraffic-priority inboundacl-rule { { dscp dscp-value| ip-precedence { pre-value| from-cos } } | cos{ pre-value | from-ipprec } |local-precedencepre-value }*OptionalApplying a QoS ProfileYou can configure to apply a QoS profile dynamically or simply apply a QoS profilemanually.Configuration prerequisitesz To configure to apply a QoS profile dynamically, make sure 802.1x is enabled bothglobally and on the port, and the authentication mode is determined. For informationabout 802.1x, refer to the 802.1x and System Guard module of this manual.z To apply a QoS profile manually, make sure the port to which the QoS profile is to beapplied is determined.z The QoS profile to be applied is determined.Configuration procedureFollow these steps to configure to apply a QoS profile dynamically:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —
