1-11# Download file config.cfg.ftp> get config.cfg200 Port command okay.150 Opening ASCII mode data connection for config.cfg.226 Transfer complete.ftp: 3980 bytes received in 8.277 seconds 0.48Kbytes/sec.This example uses the command line window tool provided by Windows. When you log in to the FTPserver through another FTP client, refer to the corresponding instructions for operation description.z If available space on the Flash memory of the switch is not enough to hold the file to be uploaded,you need to delete files not in use from the Flash memory to make room for the file, and thenupload the file again. The files in use cannot be deleted. If you have to delete the files in use tomake room for the file to be uploaded, you can only delete/download them through the Boot ROMmenu.z H3C series switch is not shipped with FTP client application software. You need to purchase andinstall it by yourself.3) Configure Switch A (FTP server)# After uploading the application, use the boot boot-loader command to specify the uploaded file(switch.bin) to be the startup file used when the switch starts the next time, and restart the switch. Thusthe switch application is upgraded. boot boot-loader switch.bin rebootFor information about the boot boot-loader command and how to specify the startup file for a switch,refer to the System Maintenance and Debugging part of this manual.FTP Banner Display Configuration ExampleNetwork requirementsConfigure the Ethernet switch as an FTP server and the remote PC as an FTP client. After a connectionbetween the FTP client and the FTP server is established and login succeeds, the banner is displayedon the FTP client.z An FTP user with username switch and the password hello has been configured on the FTPserver.z The IP addresses 1.1.1.1 for a VLAN interface on the switch and 2.2.2.2 for the PC have beenconfigured. Ensure that a route exists between the switch and the PC.
