1-8[SwitchA-GigabitEthernet1/0/1] port trunk permit vlan all# Enable GVRP on GigabitEthernet1/0/1.[SwitchA-GigabitEthernet1/0/1] gvrp[SwitchA-GigabitEthernet1/0/1] quit# Configure GigabitEthernet1/0/2 to be a trunk port and to permit the packets of all the VLANs.[SwitchA] interface GigabitEthernet 1/0/2[SwitchA-GigabitEthernet1/0/2] port link-type trunk[SwitchA-GigabitEthernet1/0/2] port trunk permit vlan all# Enable GVRP on GigabitEthernet1/0/2.[SwitchA-GigabitEthernet1/0/2] gvrp[SwitchA-GigabitEthernet1/0/2] quit# Configure GigabitEthernet1/0/3 to be a trunk port and to permit the packets of all the VLANs.[SwitchA] interface GigabitEthernet 1/0/3[SwitchA-GigabitEthernet1/0/3] port link-type trunk[SwitchA-GigabitEthernet1/0/3] port trunk permit vlan all# Enable GVRP on GigabitEthernet1/0/3.[SwitchA-GigabitEthernet1/0/3] gvrp[SwitchA-GigabitEthernet1/0/3] quit2) Configure Switch B# The configuration procedure of Switch B is similar to that of Switch A and is thus omitted.3) Configure Switch C# Enable GVRP on Switch C, which is similar to that of Switch A and is thus omitted.# Create VLAN 5.[SwitchC] vlan 5[SwitchC-vlan5] quit4) Configure Switch D# Enable GVRP on Switch D, which is similar to that of Switch A and is thus omitted.# Create VLAN 8.[SwitchD] vlan 8[SwitchD-vlan8] quit5) Configure Switch E# Enable GVRP on Switch E, which is similar to that of Switch A and is thus omitted.# Create VLAN 5 and VLAN 7.[SwitchE] vlan 5[SwitchE-vlan5] quit[SwitchE] vlan 7[SwitchE-vlan7] quit6) Display the VLAN information dynamically registered on Switch A, Switch B, and Switch E.# Display the VLAN information dynamically registered on Switch A.[SwitchA] display vlan dynamicTotal 3 dynamic VLAN exist(s).The following dynamic VLANs exist:
