H3C S5600 SERIES Operation Manual

Also see for H3C S5600 Series: Configuration Operation manual Operation manual Operation manual Operation manual

Contents

1-33[Switch] public-key local create dsa# Set the authentication mode for the user interfaces to AAA.[Switch] user-interface vty 0 4[Switch-ui-vty0-4] authentication-mode scheme# Enable the user interfaces to support SSH.[Switch-ui-vty0-4] protocol inbound ssh# Set the client’s command privilege level to 3[Switch-ui-vty0-4] user privilege level 3[Switch-ui-vty0-4] quit# Configure the authentication type of the SSH client named client 001 as publickey.[Switch] ssh user client001 authentication-type publickeyBefore performing the following steps, you must generate an RSA public key pair (using the clientsoftware) on the client, save the key pair in a file named public, and then upload the file to the SSHserver through FTP or TFTP. For details, refer to Configuring the SSH Client.# Import the client’s public key named Switch001 from file public.[Switch] public-key peer Switch001 import sshkey public# Assign the public key Switch001 to client client001.[Switch] ssh user client001 assign publickey Switch001z Configure the SSH client (taking PuTTY version 0.58 as an example)# Generate an RSA key pair.1) Run PuTTYGen.exe, choose SSH2(RSA) and click Generate.