Operation Manual – Multicast ProtocolH3C S9500 Series Routing Switches Chapter 8 MSDP Configuration8-8Operation CommandRestore the default configuration undo peer peer-addressrequest-sa-enableThe SA request message sent by a local RP will get the immediate response about allactive sources.By default, the router does not send SA request message to its MSDP peer whenreceiving the join message of a group. Instead, it waits for the arrival of SA message ofthe next period.8.2.8 Controlling the Source Information CreatedI. Filtering the multicast routing entries importedRP filters the registered sources to control the information of the active sourcesadvertised in SA message. MSDP peers can be configured to only advertise thequalified (S, G) entries in the multicast routing table when creating SA messages, that is,to control the (S,G) entries imported from the multicast routing table to the domain.Please perform the following configurations in MSDP view.Table 8-8 Filtering the multicast routing entries importedOperation CommandAdvertise only the (S, G) entries permitted bythe ACL import-source [ acl acl-number ]Remove the above configuration undo import-sourceBy default, only intra-domain sources are advertised in SA messages.If the import-source command without acl parameter is executed, no source isadvertised in SA messages.II. Filtering SA request messagesPlease perform the following configurations in MSDP view.Table 8-9 Filtering SA request messagesOperation CommandFilter all the SA request messages from aspecified MSDP peer peer peer-address sa-request-policyFilter the SA request messages of thegroups of a specified MSDP peerpermitted by the basic ACL frompeer peer-address sa-request-policyacl acl-number
