Operation Manual – PoEH3C S9500 Series Routing Switches Chapter 1 PoE Configuration1-3No Item Command Description3 Enable PoE onthe port poe enable By default, PoE is disabledon a port.4Set the maximumPoE powersupplied by theportpoe max-powermax-powerYou can set the maximumPoE power supplied by aport depending on thepower of the actual PD. Bydefault, the max-power is16800 mW.5 Set the PoEmode on the portpoe mode { signal |spare | auto }S9500 series supportsonly signal line PoE mode.By default, the PoE modeon a port is signal.6Set the PoEpriority on theportpoe priority { critical |high | low }You can set the PoEpriority on a portdepending on the practicalsituation. By default, thePoE priority on a port islow.7Display the PoEstate of a specificor all ports of theswitchdisplay poe interface[ interface-name |interface-typeinterface-num ]You can execute thiscommand in any view.Executing the display poeinterface commandwithout any option displaysthe PoE status of all theports.8Display the PoEpowerinformation of aspecific or allports of theswitchdisplay poe interfacepower [ interface-name |interface-typeinterface-num ]You can execute thiscommand in any view.Executing the display poeinterface powercommand without anyoption displays the PoEpower information aboutall the ports.9Display the PoEstatus and PoEpowerinformation ofeach carddisplay poe pse You can execute thiscommand in any viewTo cancel the configurations, use the corresponding undo commands. For detailsabout the parameters, refer to the Command Manual.
