Operation Manual – System ManagementH3C S9500 Series Routing Switches Chapter 4 System Maintenance and Debugging4-14Table 4-18 Send the configuration information to the trap bufferDevice Configuration Defaultvalue Configuration descriptionEnable info-centerBy default,info-centeris enabledOther configurations are validonly if the info-center is enabledSet the informationoutput direction to thetrapbuffer- You can configure the size of thetrap buffer at the same timeSwitchSet information source -You can define which modulesand information to be sent outand the time-stamp format ofinformation, and so on. You mustturn on the switch of thecorresponding module beforedefining output debugginginformation6) Sending the configuration information to SNMPTable 4-19 Send the configuration information to SNMPDevice Configuration Default value Configuration descriptionEnableinfo-centerBy default,info-center isenabledOther configurations are validonly if the info-center isenabledSet theinformationoutput directionto SNMP- -Set informationsource -You can define which modulesand information to be sent outand the time-stamp format ofinformation, and so on. Youmust turn on the switch of thecorresponding module beforedefining output debugginginformationSwitchConfigure SNMPfeatures - Refer to Chapter 5 SNMPConfigurationNetworkmanagementworkstationThe same as theSNMPconfiguration ofthe switch- -
