Operation Manual – PoEH3C S9500 Series Routing Switches Chapter 1 PoE Configuration1-4Note:z Before setting the maximum power supplied by a card, make sure the remainingpower of the switch is no less than the full power of the card, and the power you canset for a card ranges from 37 W to 806 W.z The reserved power for a blank slot will be recycled automatically by the system ifyou insert a PoE-incapable card into the slot.z When a card is almost fully loaded and a new PD is added, the switch will respond tothe PD according to the PoE priority set on the port.z The PoE priority of each port is based on its card. In other words, the switch cannotcompare the priorities of ports on different cards.z The sampling cycle of the power, current and voltage of ports is 1 second; thesampling cycle of the peak power and average power of both cards and ports is 5minutes1.3 Comprehensive Configuration ExampleI. Network requirementsz Two PoE-capable cards are installed in slots 3 and 5 on an S9500 series routingswitch.z GigabitEthernet3/1/1 through GigabitEthernet3/1/48 are connected with IPphones and GigabitEthernet5/1/1 through GigabitEthernet5/1/48 are connectedwith access point (AP) devices.z The IP phones connected to GigabitEthernet3/1/23 and GigabitEthernet3/1/24 donot need PoE.z GigabitEthernet3/1/48 is reserved for the use of network management, so it needshigher priority.z Slot 3 is provided with 400 W power and slot 5 is provided with full power.z The input power of the AP device connected to GigabitEhternet5/1/15 cannot begreater than 9000 mW.
