Operation Manual – NAT-URPF-VPLSH3C S9500 Series Routing Switches Chapter 3 VPLS Configuration3-14Operation CommandRemove packet redirection undo traffic-redirect inbound link-groupacl-number [ rule rule ]Note:After you configure packet redirection, the ports of the public network add to the VALN(specified join-vlan). After you remove packet redirection configuration, the ports exitfrom the corresponding VLAN.3.5.12 Configuring VPLS CharacteristicsI. Configuring VPN rate limitationUse the bandwidth command to configure the VPN rate limitation in the range of 64kbps to 4,194,303 kbps with the increment of 64. After the configuration, the systemautomatically takes the biggest number that can be exactly divided by 64 and is nomore than the setting number as the rate limitation. For example, if you specify the VPNrate limitation to be 200, then the actual is 192, three times of 64. The actuallysupported rate limitation ranges from 64 kbps to 2,097,152 kbps (included), and if thevalue you set is above 2,097,152 kbps, no rate limitation is performed. In the instance,the part of traffic beyond this bandwidth restriction is discarded by the system.Perform the following configuration in VSI-LDP view.Table 3-16 Configure VPN rate limitationOperation CommandConfigure VPN rate limitation bandwidth vpn-speedBy default, the VPN rate limitation is 102,400 kbps.II. Configuring VPN broadcast suppression percentageUse the broadcast-restrain command to configure the VPN broadcast suppressionpercentage, which is in the range of 0 to 100. You cannot set the percentage to 0. In theVSI, the part of broadcast traffic (including broadcast, multicast, and unknown unicast)beyond the suppression percentage is discarded.Perform the following configuration in VSI-LDP view.
