Checkpoint FRU/actionE143 (operating system bootlist setfrom management module bootlist) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E149 (Create boot manager node) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E14A (build vital productdata-to-operating system lookuptable)1. Go to “Checkout procedure” on page 38.2. System board and chassis.E14C (Create terminal emulatornode) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E14D (Load boot image) v Go to “Boot problem resolution” on page 153.E150 (Create host (primary) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E151 (Probing PCI bus) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E152 (Probing for adapter FCODE;evaluate if present) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E153 (End adapter FCODE probingand evaluation) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E154 (Create PCI bridge node) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E155 (Probing PCI bridge secondarybus) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E158 (Reserved) v Go to “General checkout” on page 37.E15B (Transfer control to operatingsystem (service mode boot)) v Go to “Boot problem resolution” on page 153.E15F (Adapter VPD evaluation) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E170 (Beginning of PCI bus probe) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E172 (First pass of PCI deviceprobe) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E174 (Establishing host connection) 1. Verify that bootp server is correctly configured, then retry operation.2. Verify that network connections are correct, then retry operation.3. Go to “Checkout procedure” on page 38.4. If no problems are found with bootp server or network, replace systemboard and chassis.E175 (Bootp request) 1. Verify that bootp server is correctly configured, then retry operation.2. Verify that network connections are correct, then retry operation.3. Go to “Checkout procedure” on page 38.4. If no problems are found with bootp server or network, replace systemboard and chassis.96 BladeCenter JS20 Type 8842: Hardware Maintenance Manual and Troubleshooting Guide
