assembly, the firmware code will request that you enter the serial number,as described in step 16. You must enter the blade-server serial number. Ifyou enter a different serial number, the operating system that you installedmight interpret this information as an incorrect serial number, and you mighthave to change your software-licensing agreement.v To maintain proper airflow, do not place the new label on the blade-serverbezel assembly.Also, be sure to place the RID tag label on the bottom of the blade serverchassis.11. Install the blade-server bezel assembly on the blade server (see “Installing theblade-server bezel assembly” on page 90).12. Close the blade server cover (see “Closing the blade server cover” on page92).Statement 21:CAUTION:Hazardous energy is present when the blade server is connected to thepower source. Always replace the blade cover before installing the bladeserver.13. Install the blade server into the same BladeCenter unit I/O bay from which youremoved the blade server when it contained the faulty system-board assembly.14. Turn on the blade server (see “Turning on the blade server” on page 13).Note: If you have just connected the power cords of the BladeCenter unit toelectrical outlets, you will have to wait until the power-on LED on theblade server slowly flashes before you press the power-control buttonon the blade server.15. Configure an SOL connection and attach it to this blade server.For additional information, see the IBM Eserver BladeCenter andBladeCenter T Serial Over LAN Setup Guide.16. The blade server will boot to the open firmware command to enter the serialnumber of the blade server (with the original system-board assembly).The blade server will not start until the serial number and other relevantinformation have been entered and verified at the prompts when the followingcheckpoint codes are displayed, as shown in the following example window.Depending on the blade server configuration, the text that is displayed in yoursystem window might be slightly different.E1F0E1F1D099D100 > xxxxxxx (The serial number of the blade server with the originalsystem-board assembly)D101 > xxxxxxx (Re-enter the serial number to verify)D102 > 8842 (The type number from the blade server)D103 > 8842 (Re-enter the type number to verify)D104 > xxxx (The model number from the blade server)D105 > xxxx (Re-enter the model number to verify)Chapter 9. Installing options 89
