Step 005 Select CD-ROM as the first device to be booted from theconfiguration menu boot sequence.Step 006 On the operator panel on the blade to be tested, press the CDbutton to assign the CD-ROM to the blade to be tested; then, insertthe diagnostic CD into the CD drive.Step 007 Turn on the blade to be tested.Note: This could take from 3 to 5 minute to load diagnostic fromCD. Please be patient.Progress codes will stop at E1AD; look at the CD drive activity LED(flashing). Standalone diagnostics are booting. This may take 2 to 3minutes. During this time the system may reboot and the progresscode will stop at E14D again.Note: Only firmware progress codes, not AIX progress codes, aredisplayed when booting from the diagnostic CD or bootingAIX.The screen will display “Welcome to AIX”.Note: Once you have the “Welcome to AIX” screen, another 3 to 5minutes may be required to get to the next screen; pleasebe patient.A console message will display:Standalone Diagnostic has completed loading. Please remove theDiagnostic CD from the Tray.You can leave the CD installed at this point or remove the CD(256MB RAM required to remove CD at this point). The diagnosticapplication is now loaded into memory and the CD is no longerrequired.The screen will display “Please define the system console”. Followthe instructions on the screen to define the system console. Achoice of vs100 as the system console is recommended.Notes:v At this point, you can follow the instructions to run standalonediagnostics or service aids from CD. Once you are done, youcan press the F10 key to exit diagnostics.v The operating system will not be available until the system isrebooted with the diagnostics CD removed from the CD drive, orwith a different startup drive selected.Step 008 At the Diagnostic Operating Instructions screen, press Enter.Step 009 From the Function Selection screen, use the up and down arrowkeys to select the function to be performed. Select the type ofterminal to be defined from the list provided at the prompt, forexample, type ″vs100″.Note: Use vs100 as the type of terminal; however, depending onthe terminal emulator selected, the function keys (PF#) may26 BladeCenter JS20 Type 8842: Hardware Maintenance Manual and Troubleshooting Guide
