Checkpoint FRU/actionE20B (Reading boot mode) 1. Go to “Checkout procedure” on page 38.Note: If you have already been through the checkout procedure, continuewith step 2.2. System board and chassis.E20C (Finished hardware probing;passing control to partition firmware) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E20D (Boot mode has beenobtained) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E20F (Executing from L2 cache) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E210 (Load and relocate the HIL) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E211 (CRC check of the image inflash RAM) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E212 (Getting CPU status andpresence) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E213 (Memory initialization) 1. Verify that DIMMs are correctly installed and seated, then restart server.2. Start server from backup flash to recover primary image.3. System board and chassis.E214 (Pattern 1 memory test) 1. Verify that DIMMs are correctly installed and seated, then restart server.2. Start server from backup flash to recover primary image.3. System board and chassis.E215 (Pattern 2 memory test) 1. Verify that DIMMs are correctly installed and seated, then restart server.2. Start server from backup flash to recover primary image.3. System board and chassis.E216 (Clear memory) 1. Verify that DIMMs are correctly installed and seated, then restart server.2. Start server from backup flash to recover primary image.3. System board and chassis.E217 (Start DART, HIL-base, andSDR1-base) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E218 (Copying the set of flash RAMto memory) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E219 (Saving the DIMM SPDs andthe CPU status and presence) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E21A (Executing code from memory) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E21B (Load PFW into memory) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.E21C (Executing HT initialization) 1. Go to “Checkout procedure” on page 38.2. System board and chassis.100 BladeCenter JS20 Type 8842: Hardware Maintenance Manual and Troubleshooting Guide
