IDE driveTrayRisercardShort screwsIDE connector 1(J1)IDE connector 2(J2)Attention:v Drives must be installed in the following order: IDE connector 1 (J1) first, thenIDE connector 2 (J2).v Do not install a hard disk drive in IDE connector 2 if you intend to also install anoptional I/O expansion card. The I/O expansion card occupies the same area asthe second IDE hard disk drive.v Do not press on the top of the hard disk drive when installing it. Pressing the topcould damage the hard disk drive.v IDE hard disk drives must be set to primary (master). See the documentation thatcame with your hard disk drive for instructions.Complete the following steps to install a 2.5-inch IDE hard disk drive:1. Read the safety information beginning on page iii and “Installation guidelines”on page 712. If the blade server is operating, shut down the operating system by typing theshutdown -h now command. Refer to your operating system documentation. Ifthe blade server was not turned off, press the power-control button (behind theblade-server control-panel door) to turn off the blade server. See “Blade servercontrols and LEDs” on page 14 for more information about the location of thepower-control button.3. Remove the blade server from the BladeCenter unit. (See “Removing theblade server from the BladeCenter unit” on page 73 for instructions.) Carefullyplace the blade server on a flat, static-protective surface.4. Open the blade server cover. See “Opening the blade server cover” on page74 for instructions.5. Insert the riser card from the option kit into an IDE connector on the bladeserver system board.6. Place the tray from the option kit over the riser card as shown in the precedingillustration, aligning the tray with the screws on the system board. Note thefour screws that are under the four screw holes in the tray. Set the tray asideand remove the four screws.76 BladeCenter JS20 Type 8842: Hardware Maintenance Manual and Troubleshooting Guide
