Starting the backup UEFI firmwareThis topic provides general information about starting the backup UEFI firmware.About this taskThe system board contains a backup copy area for the UEFI firmware. This is asecondary copy of the UEFI firmware that you update only during the process ofupdating the UEFI firmware. If the primary copy of the UEFI firmware becomesdamaged, use this backup copy.To force the server to start from the backup copy of the UEFI firmware, turn offthe server; then, move the UEFI boot recovery J22 jumper to the backup position(pins 2 and 3).Use the backup copy of the UEFI firmware until the primary copy is restored.After the primary copy is restored, turn off the server; then, move the UEFI bootrecovery J22 jumper back to the primary position (pins 1 and 2).Using the ServerGuide Setup and Installation CDThis topic provides information about using the ServerGuide Setup and InstallationCD.The ServerGuide Setup and Installation CD provides software setup tools andinstallation tools that are designed for your server. The ServerGuide programdetects the server model and optional hardware devices that are installed and usesthat information during setup to configure the hardware. The ServerGuideprogram simplifies operating-system installations by providing updated devicedrivers and, in some cases, installing them automatically.You can download a free image of the ServerGuide Setup and Installation CD orpurchase the CD from the ServerGuide fulfillment website at http://www.ibm.com/systems/management/serverguide/sub.html. To download the freeimage, click IBM Service and Support Site.Note: Changes are made periodically to the IBM website. The actual proceduremight vary slightly from what is described in this document.The ServerGuide program requires a supported IBM server with an enabledstartable (bootable) CD drive. In addition to the ServerGuide Setup and InstallationCD, you must have your operating-system CD to install the operating system.To start the ServerGuide Setup and Installation CD, complete the following steps:1. Insert the CD, and restart the server. If the CD does not start, see "ServerGuideproblems" in the Problem Determination and Service Guide on the IBMDocumentation CD.2. Follow the instructions on the screen to complete the following tasks:a. Select your language.b. Select your keyboard layout and country.c. View the overview to learn about ServerGuide features.d. View the readme file to review installation tips for your operating systemand adapter.e. Start the operating-system installation. you will need your operating-systemCD.Chapter 6. Configuration information and instructions 209
