806f010c-18810016 Uncorrectable error detected for [PhysicalMemoryElementName] on Subsystem[MemoryElementName].Explanation: A memory uncorrectable error has occured in DIMM 22 of memory expansion unit(MEU).May also be shown as 806f010c18810016 or 0x806f010c18810016Severity: ErrorAlert Category: CriticalServiceable: NoCIM Information: Prefix: PLAT and ID: 0138SNMP Trap ID: 41Automatically notify Support: NoUser response:1. Refer to TIP H212293 for minimum code level.2. Check the IBM support site for any applicable retain tip or firmware update that applies to this memory error.3. Swap the affected DIMM with a similar DIMM (size/type) on a different channel.4. Re-enable all DIMM slots.5. If the failure remains on the original slot, replace the DIMM that was not moved. If the failure follows the DIMMthat was moved, replace the DIMM that was swapped.6. If the problem re-occurs with the same DIMM connector, inspect DIMM connector for foreign material. Ifdamaged, replace the MEU board.806f010c-18810017 Uncorrectable error detected for [PhysicalMemoryElementName] on Subsystem[MemoryElementName].Explanation: A memory uncorrectable error has occured in DIMM 23 of memory expansion unit(MEU).May also be shown as 806f010c18810017 or 0x806f010c18810017Severity: ErrorAlert Category: CriticalServiceable: NoCIM Information: Prefix: PLAT and ID: 0138SNMP Trap ID: 41Automatically notify Support: NoUser response:1. Refer to TIP H212293 for minimum code level.2. Check the IBM support site for any applicable retain tip or firmware update that applies to this memory error.3. Swap the affected DIMM with a similar DIMM (size/type) on a different channel.4. Re-enable all DIMM slots.5. If the failure remains on the original slot, replace the DIMM that was not moved. If the failure follows the DIMMthat was moved, replace the DIMM that was swapped.6. If the problem re-occurs with the same DIMM connector, inspect DIMM connector for foreign material. Ifdamaged, replace the MEU board.806f010c-18810016 • 806f010c-18810017Appendix B. Integrated management module error messages 501
