4000001c-00000000 Watchdog [arg1] Screen Capture Occurred .Explanation: An operating-system error has occurred, and the screen capture was successful.May also be shown as 4000001c00000000 or 0x4000001c00000000Severity: InfoAlert Category: SystemServiceable: NoCIM Information: Prefix: IMM and ID: 0028SNMP Trap ID: 22Automatically notify Support: NoUser response: If there was no operating-system error, complete the following steps until the problem is solved:1. Reconfigure the watchdog timer to a higher value.2. Make sure that the IMM Ethernet-over-USB interface is enabled.3. Reinstall the RNDIS or cdc_ether device driver for the operating system.4. Disable the watchdog.If there was an operating-system error, check the integrity of the installed operating system.4000001d-00000000 Watchdog [arg1] Failed to Capture Screen.Explanation: An operating-system error has occurred, and the screen capture failed.May also be shown as 4000001d00000000 or 0x4000001d00000000Severity: ErrorAlert Category: CriticalServiceable: NoCIM Information: Prefix: IMM and ID: 0029SNMP Trap ID: 22Automatically notify Support: NoUser response: Complete the following steps until the problem is solved:1. Reconfigure the watchdog timer to a higher value.2. Make sure that the IMM Ethernet over USB interface is enabled.3. Reinstall the RNDIS or cdc_ether device driver for the operating system.4. Disable the watchdog.5. Check the integrity of the installed operating system.6. Update the IMM firmware. Important: Some cluster solutions require specific code levels or coordinated codeupdates. If the device is part of a cluster solution, verify that the latest level of code is supported for the clustersolution before you update the code.4000001c-00000000 • 4000001d-00000000380 IBM System x3850 X5 and x3950 X5 Types 7145, 7146, 7143, and 7191: Problem Determination and Service Guide
