IBM power PS700 Problem Determination And Service Manual

Also see for PS700: Overview Technical overview and introduction Installation and user guide

Contents

Table 25. 101-711 through FFC-725 SRNs (continued)SRN FFC Description and Action2604-706 2604 Error Log Analysis indicates that a fatal hardware error has occurred for the FibreChannel adapter card.This adapter was successfully taken off-line. It will remain off-line until reconfiguredor the system is rebooted. This adapter must be replaced and not brought backon-line. Failure to adhere to this action could result in data being read or writtenincorrectly or in the loss of data.2607-xxx 2607 Generic reference for 8Gb PCIe Fibre Channel Expansion Card. Go to “Performingthe checkout procedure” on page 184.2607-102 2607 Reset Test failure for the Fibre Channel adapter card. Replace the 8Gb PCIe FibreChannel Expansion Card.2607-103 2607 Register Test failure for the Fibre Channel adapter card. Replace the 8Gb PCIe FibreChannel Expansion Card.2607-104 2607 SRAM Test failure for the Fibre Channel adapter card. Replace the 8Gb PCIe FibreChannel Expansion Card.2607-105 2607 Internal Wrap Test failure for the Fibre Channel adapter card. Replace the 8Gb PCIeFibre Channel Expansion Card.2607-106 2607 Gigabit Link Module (GLM) Wrap Test failure for the Fibre Channel adapter card.Replace the 8Gb PCIe Fibre Channel Expansion Card.2607-108 2607 221 Enhanced Error Handling Failure on the bus for the Fibre Channel adapter card. Goto “Performing the checkout procedure” on page 184.2607-110 2607 Enhanced Error Handling Failure on the Fibre Channel adapter card. Replace the8Gb PCIe Fibre Channel Expansion Card.2607-201 2607 221 Configuration Register Test Failure for the Fibre Channel adapter card. Go to“Performing the checkout procedure” on page 184.2607-203 2607 PCI Wrap Test Failure for the Fibre Channel adapter card. Replace the 8Gb PCIeFibre Channel Expansion Card.2607-204 2607 221 DMA Test Failure for the Fibre Channel adapter card. Go to “Performing thecheckout procedure” on page 184.2607-205 2607 221 Error on Read/Write Operation for the Fibre Channel adapter card. Go to“Performing the checkout procedure” on page 184.2607-701 2607 Error Log Analysis indicates that the adapter self-test failed for the Fibre Channeladapter card. Go to “Performing the checkout procedure” on page 184.2607-703 2607 Error Log Analysis indicates that an unknown adapter error has occurred for theFibre Channel adapter card. Go to “Performing the checkout procedure” on page184.2607-704 2607 Error Log Analysis indicates that an adapter error has occurred for the Fibre Channeladapter card. Go to “Performing the checkout procedure” on page 184.2607-705 2607 Error Log Analysis indicates that a parity error has been detected for the FibreChannel adapter card.The adapter must be replaced immediately. Failure to do so could result in databeing read or written incorrectly.2607-706 2607 Error Log Analysis indicates that a fatal hardware error has occurred for the FibreChannel adapter card.This adapter was successfully taken off-line. It will remain off-line until reconfiguredor the system is rebooted. This adapter must be replaced and not brought backon-line. Failure to adhere to this action could result in data being read or writtenincorrectly or in the loss of data.Chapter 2. Diagnostics 147