Failing function codes 151 through 2E33Failing function codes (FFCs) identify a function within the system unit that is failing.Table 29 describes the component that each function code identifies.Note: When replacing a component, perform system verification for the component. See “Using thediagnostics program” on page 189.Table 29. Failing function codes 151 through 2E33FFC Description and notes151 1. BatteryNote: After replacing the battery:a. Set the time and date.b. Set the Network IP addresses (for blade servers that start up from a network).2. System-board and chassis assembly152 System-board and chassis assembly166 Check management-module event log for a BladeCenter blower or fan fault. See thedocumentation that comes with the BladeCenter unit.210 System-board and chassis assembly212 System-board and chassis assembly (cache problem)214 System-board and chassis assembly217 System-board and chassis assembly219 Common Memory Logic problem for memory DIMMs.Note: If more than one pair of memory DIMMs are reported missing:1. Replace the memory DIMM at the physical location code that is reported2. Replace the system-board221 System-board and chassis assembly226 System-board and chassis assembly227 System-board and chassis assembly241 Ethernet network problem282 System-board and chassis assembly292 System-board and chassis assembly (Host – PCI bridge problem)293 System-board and chassis assembly (PCI – PCI bridge problem)294 System-board and chassis assembly (MPIC interrupt controller problem)296 PCI device or adapter problem.Note: The replacement part can only be identified by the location code reported by diagnostics.2C4 System-board and chassis assembly2C6 2 GB DIMM 4 GB DIMM 8 GB DIMM2C7 System-board and chassis assembly (Memory controller)2C8 System-board and chassis assembly2C9 System-board and chassis assembly2D2 System-board and chassis assembly (Bus arbiter problem)2D3 System-board and chassis assembly2D4 System-board and chassis assembly (System/SP interface logic problem)2D5 System-board and chassis assembly (I2C primary)2D6 System-board and chassis assembly (I2C secondary)Chapter 2. Diagnostics 181
