Table 25. 101-711 through FFC-725 SRNs (continued)SRN FFC Description and Action2E23-106 2E23 External Wrap with IP Checksum Test Failure1. Check the BladeCenter management-module event log. If an error was recordedby the system, see “POST progress codes (checkpoints)” on page 84.2. Replace any parts reported by the diagnostic program.3. Replace the system-board.2E23-107 2E23 External Wrap with TCP Checksum Test Failure1. Check the BladeCenter management-module event log. If an error was recordedby the system, see “POST progress codes (checkpoints)” on page 84.2. Replace any parts reported by the diagnostic program.3. Replace the system-board.2E23-108 2E23 External Wrap with UDP Checksum Test Failure1. Check the BladeCenter management-module event log. If an error was recordedby the system, see “POST progress codes (checkpoints)” on page 84.2. Replace any parts reported by the diagnostic program.3. Replace the system-board.2E23-109 241 Network link test failure.1. Check the BladeCenter management-module event log. If an error was recordedby the system, see “POST progress codes (checkpoints)” on page 84.2. Replace any parts reported by the diagnostic program.3. Replace the system-board.2E23-201 2E23 221 Enhanced Error Handling Failure1. Check the BladeCenter management-module event log. If an error was recordedby the system, see “POST progress codes (checkpoints)” on page 84.2. Replace any parts reported by the diagnostic program.3. Replace the system-board.2E23-202 241 2E23 Network link test failure.1. Check the BladeCenter management-module event log. If an error was recordedby the system, see “POST progress codes (checkpoints)” on page 84.2. Replace any parts reported by the diagnostic program.3. Replace the system-board.2E23-601 2E23 Error log analysis indicates a hardware error.1. Check the BladeCenter management-module event log. If an error was recordedby the system, see “POST progress codes (checkpoints)” on page 84.2. Replace any parts reported by the diagnostic program.3. Replace the system-board.2E23-602 2E23 Error log analysis indicates an EEH error.1. Check the BladeCenter management-module event log. If an error was recordedby the system, see “POST progress codes (checkpoints)” on page 84.2. Replace any parts reported by the diagnostic program.3. Replace the system-board.2E23-603 2E23 Error log analysis indicates an EEPROM error.1. Check the BladeCenter management-module event log. If an error was recordedby the system, see “POST progress codes (checkpoints)” on page 84.2. Replace any parts reported by the diagnostic program.3. Replace the system-board.Chapter 2. Diagnostics 155
