14. Write the machine type, model number, and serial number of the blade server on the repairidentification (RID) tag that comes with the replacement system-board and chassis assembly. Thisinformation is on the identification label that is behind the control-panel door on the front of theblade server.Important: Completing the information on the RID tag ensures future entitlement for service.15. Place the RID tag on the bottom of the blade server chassis.16. Install the blade server into the BladeCenter unit. See “Installing the blade server in a BladeCenterunit” on page 236.17. Is the blade server managed by a management console?Yes Continue with step 18.No Turn on the blade server and then continue with step 19.Note: Because you are using a management card that was initialized from your old system boardand chassis assembly, the firmware retrieves the vital product data (VPD) from the management cardand caches it in blade server memory and you do not see any prompts for data.18. If the blade server has the VIOS installed or utilizes more than one partition, restore partition profiledata by using one of the following methods:v If this system is managed by an HMC, recover the partition profile data because the blade serveris in Recovery state. For instructions, see Correcting a Recovery state for a managed system(http://pic.dhe.ibm.com/infocenter/powersys/v3r1m5/topic/p7eav/aremanagedsystemstate_recovery.htm).Note: The blade server is turned on as part of the recovery process.v If this system is managed by an IVM, turn on the blade server, then restore the partition profiledata. Using the IVM command line, enter the rstprofdata command. For more information aboutthe rstprofdata command, see IVM rstprofdata command (http://pic.dhe.ibm.com/infocenter/powersys/v3r1m5/topic/p7hcg/rstprofdata.htm).Note: Because you are using a management card that was initialized from your old system boardand chassis assembly, the firmware retrieves the VPD from the management card and caches it inblade server memory and you do not see any prompts for data.19. Does the blade server have Fibre Channel adapters?Yes “Restore vfchost map data” on page 219. Then, continue with the next step.No Continue with the next step.20. Reset the system date and time through the operating system that you installed.For additional information, see the documentation for your operating system.262 Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)
