Table 15. B700xxxx Licensed internal code SRCs (continued)v Follow the suggested actions in the order in which they are listed in the Action column until the problem issolved. If an action solves the problem, then you can stop performing the remaining actions.v See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and whichcomponents are FRUs.B700 xxxx Error Codes Description Action1731 The VPD on a memory DIMM is notcorrect and the memory on the DIMMcannot be used, resulting in reducedmemory.Replace the MEMDIMM symbolic CRU, asdescribed in “Service processor problems” onpage 200.1732 The VPD on a processor card is notcorrect and the processor card cannot beused, resulting in reduced processingpower.Replace the system-board and chassisassembly, as described in “Replacing the FRUsystem-board and chassis assembly” on page260.1733 System firmware failure. The startupwill not continue.Look for and correct B1xxxxxx errors. If thereare no serviceable B1xxxxxx errors, or ifcorrecting the errors does not correct theproblem, contact IBM support to reset theserver firmware settings.Attention: Resetting the server firmwaresettings results in the loss of all of the partitiondata that is stored on the service processor.Before continuing with this operation,manually record all settings that you intend topreserve.The service processor reboots after IBMSupport resets the server firmware settings.If the problem persists, Replace thesystem-board, as described in “Replacing theFRU system-board and chassis assembly” onpage 260.173A A VPD collection overflow occurred. 1. Look for and resolve other errors.2. If there are no other errors:a. Update the firmware to the currentlevel, as described in “Updating thefirmware” on page 263.b. You might also have to update themanagement module firmware to acompatible level.173B A system firmware failure occurredduring VPD collection.Look for and correct other B1xxxxxx errors.4091 Informational system log entry only. No corrective action is required.4400 There is a platform dump to collect 1. Collect the platform dump information.2. Go to “Isolating firmware problems” onpage 218.4401 System firmware failure. The systemfirmware detected an internal problem.Go to “Isolating firmware problems” on page218.4402 A system firmware error occurred whileattempting to allocate the memorynecessary to create a platform dump.Go to “Isolating firmware problems” on page218.42 Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)
