IBM power PS700 Problem Determination And Service Manual

Also see for PS700: Overview Technical overview and introduction Installation and user guide

Contents

Table 14. B200xxxx Logical partition SRCs (continued)v Follow the suggested actions in the order in which they are listed in the Action column until the problem issolved. If an action solves the problem, then you can stop performing the remaining actions.v See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and whichcomponents are FRUs.B200 xxxxReference Code Description ActionB200F001 A problem occurred during thestartup of a partition. An operationhas timed out.Look for other errors and resolve them.B200F003 During the startup of a partition, thepartition processor(s) did not startthe firmware within the time-outwindow.Collect the partition dump information; then, go to“Isolating firmware problems” on page 218.B200F004 Informational system log entry only. No corrective action is required.B200F005 Informational system log entry only. No corrective action is required.B200F006 During the startup of a partition, thecode load operation for the partitionstartup timed out.1. Check the error logs and take the actions for the errorcodes that are found.2. Go to “Isolating firmware problems” on page 218.B200F007 During a shutdown of the partition,a time-out occurred while trying tostop a partition.Check for server firmware updates; then, install theupdates if available.B200F008 Informational system log entry only. No corrective action is required.B200F009 Informational system log entry only. No corrective action is required.B200F00A Informational system log entry only. No corrective action is required.B200F00B Informational system log entry only. No corrective action is required.B200F00C Informational system log entry only. No corrective action is required.B200F00D Informational system log entry only. No corrective action is required.B700xxxx Licensed internal code SRCsA B700xxxx system reference code (SRC) is an error code or event code that is related to licensed internalcode.Table 15 describes the system reference codes that might be displayed if system firmware detects aproblem. Suggested actions to correct the problem are also listed.Note: For problems persisting after completing the suggested actions, see “Checkout procedure” on page184 and “Solving undetermined problems” on page 227.Table 15. B700xxxx Licensed internal code SRCsv Follow the suggested actions in the order in which they are listed in the Action column until the problem issolved. If an action solves the problem, then you can stop performing the remaining actions.v See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and whichcomponents are FRUs.B700 xxxx Error Codes Description Action0102 System firmware detected an error. Amachine check occurred during startup. 1. Collect the event log information.2. Go to “Isolating firmware problems” onpage 218.Chapter 2. Diagnostics 39