Table 16. BA000010 to BA400002 Partition firmware SRCs (continued)v Follow the suggested actions in the order in which they are listed in the Action column until the problem issolved. If an action solves the problem, then you can stop performing the remaining actions.v See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and whichcomponents are FRUs.Error code Description ActionBA180012 PCI device runtime error, bridge infreeze state 1. Go to “Checkout procedure” on page 184.2. Replace the system-board, as described in“Replacing the FRU system-board andchassis assembly” on page 260.BA180014 MSI software error 1. Reboot the blade server.2. If the problem persists:a. Go to “Checkout procedure” on page184.b. Replace the system-board, as describedin “Replacing the FRU system-boardand chassis assembly” on page 260.BA180020 No response was received from a slotduring PCI probing. 1. Reboot the blade server.2. If the problem persists:a. Go to “Checkout procedure” on page184.b. Replace the system-board, as describedin “Replacing the FRU system-boardand chassis assembly” on page 260.BA180099 PCI probe error; bridge in freeze state,slot in reset state 1. Reseat the PCI adapter card.2. Check for adapter firmware updates; then,install the updates if available.3. Check for server firmware updates; then,install the updates if available.4. Replace the PCI adapter card.5. If the problem persists:a. Go to “Checkout procedure” on page184.b. Replace the system-board, as describedin “Replacing the FRU system-boardand chassis assembly” on page 260.BA180100 The FDDI adapter Fcode driver is notsupported on this server.IBM may produce a compatible driver in thefuture, but does not guarantee one.BA180101 Stack underflow from fibre-channeladapter 1. Go to “Checkout procedure” on page 184.2. Replace the system-board, as described in“Replacing the FRU system-board andchassis assembly” on page 260.BA190001 Firmware function to get/settime-of-day reported an error 1. Go to “Checkout procedure” on page 184.2. Replace the system-board, as described in“Replacing the FRU system-board andchassis assembly” on page 260.74 Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)
