Table 16. BA000010 to BA400002 Partition firmware SRCs (continued)v Follow the suggested actions in the order in which they are listed in the Action column until the problem issolved. If an action solves the problem, then you can stop performing the remaining actions.v See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and whichcomponents are FRUs.Error code Description ActionBA060022 The environment variable “boot-device”contained an entry that exceeded 255characters in length1. Using the SMS menus, set the boot list tothe default boot list.2. Shut down; then, start up the blade server.3. Use SMS menus to customize the boot listas required.4. If the problem persists:a. Go to “Checkout procedure” on page184.b. Replace the system-board, as describedin “Replacing the FRU system-boardand chassis assembly” on page 260.BA060030 Logical partitioning with sharedprocessors is enabled and the operatingsystem does not support it.1. Install or boot a level of the operatingsystem that supports shared processors.2. Disable logical partitioning with sharedprocessors in the operating system.3. If the problem remains:a. Go to “Checkout procedure” on page184.b. Replace the system-board, as describedin “Replacing the FRU system-boardand chassis assembly” on page 260.BA060060 The operating system expects an IOSPpartition, but it failed to make thetransition to alpha mode.1. Verify that:v The alpha-mode operating system imageis intended for this partition.v The configuration of the partitionsupports an alpha-mode operatingsystem.2. If the problem remains:a. Go to “Checkout procedure” on page184.b. Replace the system-board, as describedin “Replacing the FRU system-boardand chassis assembly” on page 260.BA060061 The operating system expects anon-IOSP partition, but it failed to makethe transition to MGC mode.1. Verify that:v The alpha-mode operating system imageis intended for this partition.v The configuration of the partitionsupports an alpha-mode operatingsystem.2. If the problem remains:a. Go to “Checkout procedure” on page184.b. Replace the system-board, as describedin “Replacing the FRU system-boardand chassis assembly” on page 260.62 Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)
