Table 16. BA000010 to BA400002 Partition firmware SRCs (continued)v Follow the suggested actions in the order in which they are listed in the Action column until the problem issolved. If an action solves the problem, then you can stop performing the remaining actions.v See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and whichcomponents are FRUs.Error code Description ActionBA01B014 Closing the BOOTP node failed 1. Reboot the blade server.2. If the problem persists:a. Go to “Checkout procedure” on page184.b. Replace the system-board, as describedin “Replacing the FRU system-boardand chassis assembly” on page 260.BA01B015 The BOOTP discover server timed out Perform the following actions that checkpointCA00E174 describes:1. Verify that:v The bootp server is correctly configured;then, retry the operation.v The network connections are correct;then, retry the operation.2. If the problem persists:a. Go to “Checkout procedure” on page184.b. Replace the system-board, as describedin “Replacing the FRU system-boardand chassis assembly” on page 260.BA01D001 Opening the DHCP node failed 1. Reboot the blade server.2. If the problem persists:a. Go to “Checkout procedure” on page184.b. Replace the system-board, as describedin “Replacing the FRU system-boardand chassis assembly” on page 260.BA01D020 DHCP failed to read from the network 1. Verify that the network cable is connected,and that the network is active.2. If the problem persists:a. Go to “Checkout procedure” on page184.b. Replace the system-board, as describedin “Replacing the FRU system-boardand chassis assembly” on page 260.BA01D030 DHCP failed to write to the network 1. Verify that the network cable is connected,and that the network is active.2. If the problem persists:a. Go to “Checkout procedure” on page184.b. Replace the system-board, as describedin “Replacing the FRU system-boardand chassis assembly” on page 260.Chapter 2. Diagnostics 57
