Icom IC-E7 Instruction Manual

Also see for IC-E7: Service manual Service manual Instruction manual

Contents

Icom IC-E7 Instruction Manual Manual pdf 12 page image

VIIQUICK REFERENCE GUIDE■ Programmed scan operation50 channels of memories in 25 pairs are used to specifyscanning ranges for programmed scan operation. The pro-grammed scan scans between “xxA” and “xxb” (xx=00 to 24)channels. Therefore, before operating the programmed scan,different frequencies must be programmed into the “A” and“b” channels.DD Programming scan edgesA start and stop frequency must be programmed into a pairof "xxA" or "xxb" channels.1. Setting frequencyIn VFO mode, set the desired operating frequency and mode.• When “ ” indicator is displayed, push [V/M] (SKIP •S.MW) to selectthe VFO mode.2. Selecting a scan edge channel “A”Push and hold [V/M] (SKIP•S.MW) for 1sec. to enter select memory writemode ( 1 short and 1 long beepsound) , then rotate [DIAL] to selectthe desired scan edge channel “A.”• “ ” indicator and scan edge channelnumber blink.3. Writing a memory channelPush and hold [V/M] ( SKIP • S . MW ) for 1 sec. until 3 beepssound.• Scan edge channel “b” is automatically selected when continuing topush [V/M] (SKIP •S.MW) after programming.• After programming is completed, the display returns to VFO indica-tion.4. Selecting a scan edge channel “b”Push and hold [V/M] (SKIP•S.MW) for 1sec., then rotate [DIAL] to select thedesired scan edge channel “b.”• “ ” indicator and scan edge channelnumber blink.• When the scan edge channel “b” is already selected at step 3, con-tinuing to push [V/M] (SKIP•S.MW) after programming, skip this step.5. Writing a memory channelPush and hold [V/M] ( SKIP • S . MW ) for 1 sec. until 3 beepssound.• The next scan edge channel “A” is automatically selected when con-tinuing to push [V/M] (SKIP •S.MW) after programming.• After programming is completed, the display returns to VFO indica-tion.ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519