Icom IC-E7 Instruction Manual

Also see for IC-E7: Service manual Service manual Instruction manual

Contents

Icom IC-E7 Instruction Manual Manual pdf 56 page image

438 PRIORITY WATCHDD Memory channel watch and memory scan watchq Select VFO mode, then set an operating frequency.• TX channel can also be selected.wPush [V/M] ( SKIP • S . MW ) to enter memory mode, then se-lect the channel(s) to be watched.For memory channel watch:Rotate [DIAL] to select the desired memory channel.For memory scan watch:Push and hold [CALL] (MODE•SCAN) for 1 sec. to enter scantype selection condition to select the scan type, then push[CALL] (MODE•SCAN ) again to start memory/bank scan.eWhile pushing and holding [FUNC], push and hold[SQL] (ATT•SET) for 1 sec. to enter set mode.r Rotate [DIAL] to select “PRIO.”tWhile pushing and holding [FUNC], rotate [DIAL] to turnthe priority watch ON.• Select “BELL” if the priority beep function is necessary.y Push [SQL] (ATT•SET) to exit set mode and start the watch.• “PRIO” indicator appears.• The transceiver checks the memory/bank channel(s) every 5 sec.• The watch resumes according to the selected scan resume con-dition. (p. 41)uWhile pushing and holding [FUNC], push [SQL] (ATT•SET)to cancel the watch.ATTDTCST SQLWFMAM -DUPLOWVOL PRIO PSKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO PSKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO PSKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO PSKIPMR519• During priority watchMonitors VFO frequencyfor 5 sec.Pauses on a memory (bank) channelwhen a signal is received.• During priority watch with priority beepEmits beep and blinks “S” indicator when a signal is re-ceived on a memory (bank) channel.ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519 ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519Priority ON Priority beep ONSCANS.MWSETATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519SET[DIAL]S.MWSCANAfter 1 sec.■ Priority watch operation