377 SCAN OPERATIONq Select memory mode with [V/M] (SKIP •S.MW).w Set the squelch to the point where noise is just muted.ePush and hold [CALL] ( MODE • SCAN ) for 1 sec. to enterscan type selection mode.r Rotate [DIAL] to select the desired scanning type.• “M ALL” for all memory scan; “B ALL” for all bank scan; “B LINK”for bank link scan; “BANK” for bank scan.tPush [CALL] ( MODE • SCAN ) momentarily to start the se-lected scan.• Scan pauses when a signal is received.• Rotate [DIAL] to change the scanning direction, or resumesmanually.y To stop the scan, push [CALL] (MODE •SCAN ).IMPORTANT!: To perform memory or bank scan, 2 ormore memory/bank channels MUST be programmed, oth-erwise the scan never starts.ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519• During all memory/all bank/bank link scan • During bank scanFM AM DUP SQL DTCSTWFM AM DUP SQL DTCSTWATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519 ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519• All memory scan selection • All bank scan selection• Bank link scan selection • Bank scan selectionProgrammed bankSCANS.MWSETSCAN[DIAL]S.MW■ Memory/bank scanPush Push and hold Dual operation
