Icom IC-E7 Instruction Manual

Also see for IC-E7: Service manual Service manual Instruction manual

Contents

Icom IC-E7 Instruction Manual Manual pdf 51 page image

387SCAN OPERATION7■ Auto memory write scanThis scan is useful for searching a specified frequency rangeand automatically storing busy frequencies into memorychannels. The same frequency ranges used for program scanare used for auto memory write scan.q Select VFO mode with [V/M] (SKIP •S.MW), if necessary.wPush and hold [CALL] ( MODE • SCAN ) for 1 sec. to enterscan type selection condition.e Rotate [DIAL] to select the desired scanning type.• “ALL” for full scan; “BAND” for band scan, “PROGxx” for pro-grammed scan (xx= 0 to 24; programmed scan edges numbersonly displayed)r Push [CALL] (MODE •SCAN ) to start the scan.tPush [V/M] ( SKIP • S . MW ) to toggle the automatic memorywrite function ON and OFF.• “ ” indicator blinks during auto memory write.yPush [CALL] (MODE •SCAN ) to stop scan.DD During auto-memory write scanning:• When a signal is received, scan pauses and the frequencyis stored into auto memory write channel group (000♦–199♦).- 2 short beeps sound when stored.• Scan resumes after frequency storing.• When all channels are stored, the scan cancels automati-cally and 1 long beep sounds.DD Re-calling the stored frequencies:qPush [V/M] (SKIP •S.MW) to select memory mode.wPush [BAND] ( TS • LOCK ) several times, or while pushingand holding [BAND] ( TS•LOCK ), rotate [DIAL] to select theauto memory write channel group.• “♦” appears.e Rotate [DIAL] to select the desired channel.DD Clearing the stored frequencies:q Select the auto memory write channel group.wWhile pushing and holding [FUNC], push and hold[V/M] (SKIP •S.MW) for 1 sec. to clear the all channels con-tents.• 1 short and 1 long beeps sound.NOTE: The auto memory write channel contents CANNOTbe cleared as an independent channel. Thus it is a goodidea to copy the contents into a memory channel.ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519AppearsSCANS.MWSETATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519SCAN[DIAL]“ ” indicator blinks