45TONE SQUELCH AND POCKET BEEP9The tone or DTCS squelch opens only when receiving a sig-nal with the same pre-programmed subaudible tone or DTCScode, respectively. You can silently wait for a signal using thesame specified tone.q Set the desired frequency in FM mode.wWhile pushing and holding [FUNC], push and hold[SQL] (ATT•SET) for 1 sec. to enter set mode.e Rotate [DIAL] to select “T/TSQL.”rWhile pushing and holding [FUNC], rotate [DIAL] to selectthe desired tone squelch condition from “TSQL,” “P BEEP,”“DTCS” and “P DTCS.”t Push [SQL] (ATT•SET) to exit set mode.• One of “TSQL,” TSQLS,” “DTCS” or “SDTCS” appears ac-cording to the tone selection in the step r.yWhen a signal with a matching tone is received, thesquelch opens and the transceiver emits audio.When pocket beep function is activated, the transceiveralso emits beep tones and blinks “S.”• Beep tones sound and “S” blinks for 30 sec.u Push [FUNC] to manually stop the beeps and blinking.• “S” disappears and the pocket beep function is deactivated.iTo cancel the tone squelch or DTCS, select “OFF” with the“T/TSQL” in the set mode, as described in step r.ATTDTCST SQLWFMAM -DUPLOWVOL PRIO PSKIPMR519 ATTDTCST SQLWFMAM -DUPLOWVOL PRIO PSKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO PSKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO PSKIPMR519Tone squelch selection Tone squelch with pocketbeep function selectionDTCS selection DTCS with pocket beepfunction selectionATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIP MR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519Tone squelch selection Tone squelch with pocketbeep function selectionDTCS selection DTCS with pocket beepfunction selectionSubaudible tone OFF Repeater tone selection■ Tone/DTCS squelch operation