Icom IC-E7 Instruction Manual

Also see for IC-E7: Service manual Service manual Instruction manual

Contents

Icom IC-E7 Instruction Manual Manual pdf 24 page image

■ Setting a frequencyq Push [V/M] (SKIP •S.MW) to select VFO mode, if necessary.w Select the desired frequency band with [BAND] (TS•LOCK).• Or, while pushing and holding [BAND] ( TS•LOCK ), rotate [DIAL]to select the desired frequency band.e Rotate [DIAL] to select the desired frequency.• The frequency changes according to the preset tuning steps.See the section at right for setting the tuning step.• While pushing and holding [FUNC], rotate [DIAL] to change thefrequency in 1 MHz steps (default).The 1 MHz tuning step (dial select step) can be set to100 kHz, 1 MHz or 10 MHz tuning steps in set mode. Seep. 17 for details.■ Setting a tuning stepThe tuning step can be selected for each frequency band.The following tuning steps are available for the IC-E7.• 5.0 kHz* • 6.25 kHz* • 8.33 kHz † • 9.0 kHz ‡ • 10.0 kHz• 12.5 kHz • 15.0 kHz • 20.0 kHz • 25.0 kHz • 30.0 kHz• 50.0 kHz • 100.0 kHz • 200.0 kHz* Appears for below the 500 MHz bands only.† Appears for the VHF air band only.‡ Appears for the AM broadcast band only.DD Tuning step selectionqPush [V/M] ( SKIP • S . MW ) toselect VFO mode, if neces-sary.wPush [BAND] ( TS • LOCK )several times to select thedesired frequency band.• Or, while pushing and hold-ing [BAND] (TS•LOCK), rotate[DIAL] to select the desiredfrequency band.eWhile pushing and holding[FUNC], push [BAND]( TS • LOCK ) momentarily toenter tuning step set mode.rRotate [DIAL] to select thedesired tuning step.tPush [BAND] ( TS•LOCK ) toreturn to VFO mode.SCANSETS.MWATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519[DIAL]5 kHz tuning stepSCANSETS.MWATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519[DIAL] changes the fre-quency according to theselected tuning step.While pushing [FUNC],[DIAL] changes the frequen-cy in 1 MHz steps (default).[DIAL]113 FREQUENCY AND CHANNEL SETTING