Icom IC-E7 Instruction Manual

Also see for IC-E7: Service manual Service manual Instruction manual

Contents

Icom IC-E7 Instruction Manual Manual pdf 74 page image

6111 OTHER FUNCTIONSD Cloning using a personal computerData can be cloned to and from a personal computer (Mi-crosoft ® Windows ® 98/98SE/Me/2000/XP) using the optionalCS-P7 CLONING SOFTWARE and the optional OPC-478/478UCLONING CABLE. Consult the CS-P7 CLONING SOFTWARE HELPfile for details.D Cloning errorNOTE: DO NOT push any key on the sub-transceiver dur-ing cloning. This will cause a cloning error.When the display appears as below, a cloning error has oc-curred.In such a case, both transceivers automatically return to theclone standby condition and cloning must be repeated.■ Auto power-off functionThe IC-E7 can be set to automatically turn OFF after a spec-ified period in which no operation is performed.120 min., 90 min., 60 min., 30 min. and OFF can be specified.The specified period is retained even when the transceiver isturned OFF by the auto power-off function. To cancel thefunction, select “OFF” in step e below.qWhile pushing and holding [FUNC], push and hold[SQL] (ATT•SET) for 1 sec. to enter set mode.w Rotate [DIAL] to select “AP OFF.”• Turn the expanded set mode ON for selection. (p. 39)eWhile pushing and holding [FUNC], rotate [DIAL] to selectthe desired time or to turn the function OFF.r Push [SQL] (ATT•SET) to exit set mode.SCANS.MWSETATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519After 1 sec.SET[DIAL]USING EXPANDED SET MODEMicrosoft and Windows are registered trademarks of Microsoft Corporation inthe U.S.A. and other countries.ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519CAUTION: Be sure to turn OFF the transceiver when con-necting the cloning cable, otherwise cloning op-erations cannot be performed.