Icom IC-E7 Instruction Manual

Also see for IC-E7: Service manual Service manual Instruction manual

Contents

Icom IC-E7 Instruction Manual Manual pdf 49 page image

367SCAN OPERATION7Scan edges can be programmed in the same manner asmemory channels. Scan edge frequencies are programmedinto scan edges, 00A/00b to 24A/24b, in memory channels.q Push [V/M] (SKIP •S.MW) to select VFO mode, if necessary.w Set the desired frequency:➥ Select the desired band with [BAND] ( TS•LOCK ).➥ Set the desired frequency with [DIAL].➥ Set other data (e.g. offset frequency, duplex direction, sub-audible tone frequency, etc.) , if desired.ePush and hold [V/M] (SKIP •S.MW) for 1 sec. to enter selectmemory write mode.• 1 short and 1 long beeps sound.• “ ” indicator and memory channel number blink.rRotate [DIAL] to select the desired programmed scanedge channel from 00A to 24A.t Push and hold [V/M] (SKIP •S.MW) for 1 sec.• 3 beeps sound• The other scan edge channel “b,” 00b to 24b, is automaticallyselected when continuing to push [V/M] ( SKIP • S . MW ) after pro-gramming.yTo program a frequency for the other pair of scan edges,00b or 24b, repeat steps w and t.• If the same frequency is programmed into a pair of scan edges,programmed scan will not function.SCANS.MWSETS.MW[DIAL][EXAMPLE]: Programming 145.300 MHz into scan edge 03A.ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIP MR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519Push for 1 sec. RotateS.MW Push for 1 sec.S.MW■ Scan edges programming