q Select VFO mode with [V/M] (SKIP •S.MW), if necessary.• Select the desired frequency band with [BAND] (TS•LOCK), if de-sired.w Set the squelch to the point where noise is just muted.ePush and hold [CALL] ( MODE • SCAN ) for 1 sec. to enterscan type selection condition.r Rotate [DIAL] to select the desired scanning type.• “ALL” for full scan; “BAND” for band scan, “PROGxx” for pro-grammed scan (xx= 0 to 24; programmed scan edges numbersonly displayed)tPush [CALL] (MODE •SCAN ) again to start the scan• Scan pauses when a signal is received.• Rotate [DIAL] to change the scanning direction, or resumesmanually.• To stop the scan, push [CALL] (MODE •SCAN ).About the scanning steps: The selected tuning step ineach frequency band (in VFO mode) is used during scan.ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519• During full/band scan • During programmed scanSCANS.MWSETATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519• Full scan selection• Band scan selection• Programmed scan selectionSelectable between “ 0” to “24”if programmedSCAN[DIAL]■ Full/band/programmed scan357 SCAN OPERATIONPush Push and hold Dual operation
