Icom IC-E7 Instruction Manual

Also see for IC-E7: Service manual Service manual Instruction manual

Contents

Icom IC-E7 Instruction Manual Manual pdf 37 page image

246MEMORY/CALL CHANNELS■ General descriptionThe IC-E7 has 1050 memory channels including 50 scanedge memory channels (25 pairs) for storage of often-usedfrequencies. And a total of 18 memory banks, A to H, J, L, N,O to R, T, U and Y are available for storing groups of fre-quencies, etc. Up to 100 channels can be assigned into abank.DD Memory channel contentsThe following information can be programmed into memorychannels:• Operating frequency (p. 11)• Operating mode (p. 14)• Duplex direction (DUP or –DUP) with an offset frequency(pgs. 19, 20)• Subaudible tone encoder (p. 22), tone squelch or DTCSsquelch ON/OFF (p. 45)• Subaudible tone frequency (p. 21), tone squelch fre-quency or DTCS code with polarity (pgs. 46, 47)• Scan skip information (p. 39).■ Memory channel programmingq Push [V/M] (SKIP •S.MW) to select VFO mode.w Set the desired frequency:➥ Select the desired band with [BAND] ( TS•LOCK ).➥ Set the desired frequency with [DIAL].➥ Set other data (e.g. offset frequency, duplex direction, sub-audible tone frequency, etc.) , if desired.ePush and hold [V/M] (SKIP •S.MW) for 1 sec. to enter selectmemory write mode.• 1 short and 1 long beep sound.• “ ” indicator and memory channel number blink.r Rotate [DIAL] to select the desired channel.• Call channels (C0, C1), VFO (VF) and scan edge channels(00A/00b to 24A/24b), as well as regular memory channels, canbe programmed in this way.• While pushing and holding [FUNC], rotate [DIAL] to select mem-ory channel in 10 channel steps.t Push and hold [V/M] (SKIP •S.MW) for 1 sec.• 3 beeps sound• Memory channel number automatically increases when contin-uing to push [V/M] (SKIP •S.MW) after programming.[EXAMPLE]: Programming 439.370 MHz into memory channel 20 (blank channel).ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIP MR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519ATTDTCST SQLWFMAM -DUPLOWVOL PRIO P SKIPMR519Push for 1 sec. RotateS.MW Push for 1 sec.S.MW56