114 Configuring Enterprise Edge ServicesEnterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01Link at CO Some exchanges respond to a Link signal (ƒ‡⁄) byproviding an alternative line for making outgoing calls. When youenable Link at CO, the system applies the restrictions on outgoingcalls to the digits dialed after the Link signal, and the call on thealternative line is subject to all restrictions. Disabling Link at COprevents a Link signal from resetting the Enterprise Edgerestrictions in cases where the host exchange does not provide analternative line.Values: Y or N (Default: N)Use auxiliary ringer Allows you to turn the auxiliary ringer on or off. Refer to Useauxiliary ringer on page 117.Values: Y or N (Default: N)Full autohold Enables or disables full autohold. When enabled, if a caller selectsan idle line but does not dial any digits, that line is automaticallyplaced on hold if you then select another line. Applies to loop startand VoIP trunks. Full autohold is always in place for T1 E&Mtrunks; it has no meaning for incoming-only T1 DID trunks.The default setting should be changed only if Full autohold isrequired for a specific application.Values: Y or N (Default: N)Loss package Allows you to select the appropriate loss/gain and impedancesettings for each line. For more information refer to Losspackage on page 117.Values: Short CO, Medium CO, Long CO, Short PBX, LongPBX (Default: Medium CO)Signalling Defines the signal type for the line. Applies to T1 E&M or T1DID trunks. The immediate setting does not appear for T1 E&Mor T1 DID trunks connected to an EE-DTM if the Dial mode is setto tone.Make sure that this matches the signal type programmed for thetrunk at the other switch.Values: WinkStart, Immediate, DelayDial (Default: Winkstart)ANI Number Defines whether the telephone number of the caller will becollected for this line. Applies to T1 E&M and T1 DID trunks.For T1 E&M and T1 DID trunks connected to an EE-DTM, thissetting only appears if Signalling is set to WinkStart.The central office must deliver ANI/DNIS in DTMF mode. Noadditional equipment is required.Values: Y or N (Default: N)DNIS Number Defines whether the digits dialed by an external caller on this linewill be collected. Applies to T1 E&M trunks. For T1 E&M trunksconnected to an EE-DTM, this setting only appears if Signalling isset to WinkStart and Answer mode is set to Manual.These digits are required for some third-party softwareapplications.Values: Y or N (Default: N)Attribute Description
