Configuring Enterprise Edge Services 165P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations GuideProgramming Network Name DisplayThe Business name and the Set name make up the information that is used for theoutgoing Calling name or connected name.Calling/connected name is only sent once the Business name is programmed. Toprogram the Business name, see General Settings on page 147. It is recommendedthat you use a blank space for the last character of the Business name to act as aseparator between the Business name and Set name.To program the Set Name:1. Under Services, Telephony Services, Terminals & sets, General settingsselect the set number of the telephone2. In the Business name box, type the Business name (7 characters).3. Other areas that must also be programmed include:• The OLI number, see OLI number on page 95.• Under Telco Features, the Call ID must be set to Yes, see Auto called ID onpage 107• Under Lines, type the set number where you want the CLID to appear, seeCLID set on page 113.Outgoing name and number blocking (ONN)When you activate, ƒ°⁄· blocks the outgoing name and number(ONN) on a per call basis. When you use this feature, the system flags the call tothe CO so that the name and number does not present to the person you call.Enterprise Edge alerts the CO by two methods and each depends on the type oftrunk involved in placing the outgoing call. Analog trunks use a dialing digitsequence called a Vertical Service Code (VSC). The VSC differs from region toregion and must be programmed. Analog trunks with both tone and pulse dialingtrunks can have separate VSCs. PRI trunks have only one VSC.To configure ONN:1. Under Services, Telephony Services, Telco features, two options areavailable.2. For analog trunks under Voice message center numbers, ONN blocking,Analog VCS, Tone:None. You can choose F78, (0-9), *, #.3. Type a new tone dialing Name and Number blocking digit sequence.4. For non-analog trunks under Voice message center numbers, ONNblocking, Pulse:None. You can choose F78, (0-9), *, #.5. Type a new pulse dialing Name and Number blocking digit sequence.