154 Configuring Enterprise Edge ServicesEnterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01CAP assignmentThe CAP assignment setting designates a telephone as a central answering position(CAP). The CAP must be an M7324 telephone, and may have one or two CAPmodules attached. You can install a maximum of five CAPs on Enterprise Edge.The CAP can:• Monitor the busy/not busy and Do not disturb status of Enterprise Edgetelephones.• Answer external calls on up to 120 lines, and extend calls to other EnterpriseEdge telephones.• Send up to 30 messages to other Enterprise Edge telephones.• Provide up to 96 extra memory buttons for the M7324 telephone.To configure a CAP assignment:1. Choose Services, Telephony Services, General Settings, CAP assignment.2. Click on the CAP you want to program (CAP 1-CAP 5). The CAP # windowappears.3. Type the set number of the M7324 telephone you want to designate as a CAP.Dialing planDialing timeoutDialing timeout specifies how long Enterprise Edge will wait between user-dialeddigits. This value allows Enterprise Edge to determine when the user has stoppeddialing.The user can also use the ‘#’ key to tell Enterprise Edge that they are finisheddialing however, this is not usually required except for international calls where thenumber of digits dialed varies.1. Click on Dialing plan. The Dialing plan window appears.2. In the Dialing timeout box select a timeout value. You can select thefollowing values (in seconds): 3, 4, 5, 6, 8, 10, 15.TipsIf CAP modules are attached to an M7324 telephone that has not beenprogrammed as a CAP, then no CAP settings are assigned. If a CAP module(or modules) is relocated with the M7324 telephone, the settings are retained.