280 MaintenanceEnterprise Edge 2.0 Programming Operations Guide P0911588 Issue 013. Click OK. The system disables the module in one minute (or immediately, ifthe status is idle). Click Cancel to leave this display without disabling themodule.Enable a moduleUse the following procedure to enable a disabled module.1. Choose Resources., Media Bay Modules and click on the Bus associatedwith the module you wish to enable.The State box indicates that the module is disabled and the Configurationmenu is enabled.2. On the Configuration menu click Enable.The system displays a message indicating that the module is being enabled.Identify a device connected to the systemYou may wish to check a device’s version number for compatibility with thesystem. Use the following procedure to display status information for any deviceconnected to the system.1. Choose Resources, Media Bay Modules, Bus ##, Port #, Channels.2. Click on the B1 heading to display the device connected to the B1 channel orclick B2 to display the device connected to the B2 channel.The window displays the device, its type, the version number of the deviceand its state.3. If there is an add-on device attached to the telephone such as a centralanswering position module or a Busy Lamp Field, expand the B1 or B2heading and click on the Addons heading to display the add-on device.The following table lists some of the device types that may appear on the EnterpriseEdge device identification display.Display ExplanationM7100 M7100 telephoneM7310 M7310 telephoneM7324 M7324 telephone1: CAP1 First CAP module attached to an M7324 telephone2: CAP2 Second CAP module attached to an M7324 telephoneNortel Networks ATA 2 Analog Terminal Adapter
