212 Configuring Enterprise Edge ServicesEnterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01The SAP Parameters settings are:The SAP Input/Output Filters settings display the Service Type, Service Nameand Network Mask. To add an input or output SAP Filter refer to Adding SAPfilters for IPX routing on page 214.The Static Routes settings display the Static Route number, Net Number, NextHop Mac Address, Ticks and Hops. To add a Static Routes refer to AddingStatic Routes for IPX Routing on page 214.The Static Service settings display the Static Service number, Type, Name,Network, Node, Socket and Hops. To add a Static Service refer to AddingStatic Service for IPX on page 215.Attribute DescriptionSAP State Allows you to enable or disable SAP for this interface.The values are Enabled or Disabled.AdvertiseServicesAllows you to enable or disable the advertisement or SAP services on theinterface to remote routers.Possible values are Enabled or Disabled. The default value is Enabled.Accept ServiceAdvertisementsAllows you to enable or disable the acceptance of advertisement of SAPservices from remote routers.Possible values are Enabled or Disabled. The default value is Enabled.Update Mode Allows you to select an update mode for SAP on the interface. The availableoptions are:Standard update mode sends periodic updates at interval you define in theUpdate Interval box.Autostatic update mode sends a routing table update when other routersconnected to this interface request it. New routes to this interface, using SAP,are stored as static routes in the routing table for this interface and remainuntil you delete them.No Update mode never updates the routing tables on the current interface.If you are configuring IPX routing on a LAN interface, the default value isStandard. If you are configuring IPX routing for a WAN interface, thedefault value is No Update.Update Interval Allows you to set the interval (in seconds) at which SAP announcements areupdated. For example, if you set the Update Mode to Standard, the SAPannouncements are updated at the interval you specify in the Update Intervalbox. The possible values 5 to 86400 seconds. The default value is 60 seconds.Aging IntervalMultiplierA multiplier used to determine when a SAP announcements coming to thisinterface expire. For example, if the update interval is set to 60 seconds andyou enter a value of 3 in the Aging Interval Multiplier, a SAP announcementremains valid for a maximum of 180 seconds (3 X 60) from the lastannouncement. The possible values are 3 to 100.The default value is 3.
